auna Connect 150 SE Mode D'emploi page 37

After this, the following options are available, to define if the time to be
synchronized from radios: "Update from DAB", "Update from FM", "Update
from Network" or "No update".
If you choose "Update from Network" you must indicate your time zone in
the next window.
Next choose "ON" for summer time, otherwise select "OFF".
If you choose "No update", you will have to enter the date and time
manually.
"AM"/ "PM" displays only if you have chosen the 12-hour time format. Select
"AM" for the morning hours or "PM" for the afternoon hours.
Setting network - Firstly the device asks if keep network connected. If you
want to control the device in all operating modes via the app, select "YES".
If choosing "NO", it is not possible to control the device from the app in
the (Standby, AUX IN, FM, DAB) operating modes. Note that the power
consumption in standby mode will be higher when the network connection
is kept up.
Any WLAN networks found are listed on the display, along with their names.
After selecting the network, you will be asked for input a standard
encryption. To enter the network's key, use the reel or direction keys on the
remote control to move the cursor through the characters and press "OK" to
confirm. As each character is selected, the key is built up near the top of the
display.
There are three options accessible by tuning the navigate reel back before
the first characters – Backspace, OK and Cancel.
[WPS] There will be hints for the type of network –if your network device
supports WPS function.
Use one of the following methods of connection:
• Push button: The device prompts you to press the connect button on
the router. It then scans for a ready Push Button Connect network and
connects.
• Pin: The device generates an 8-digit code number which you enter into
the wireless router, access point, or an external registrar.
• Skip WPS: Enter key as for a standard encrypted network.
For more information on setting up a WPS encrypted network, see your
WPS router's instructions. Device attempts to connect to the selected
network. It will show connected if the setup is successful. If connecting fails,
it returns to a previous screen to try again. Once completed, press OK to
quit the setup wizard.
EN
37