Publicité
Les langues disponibles
Les langues disponibles
Assembling the pedestal / Setting-up
Accessories for pedestal assembly
Assembly screw
...........................4
Assembling the pedestal
The numbers (such as
Assemble the poles correctly by referring to the illustrations below.
1. Installing the poles
Outside
Base
Pole
Insert the poles into the left and right holes in
the underside of the base so that they fit
securely as shown in the illustration above.
Setting-up
1. Setting up the plasma
television unit
Plasma television
Spread a clean cloth or similar material over
a level floor or base, and place the plasma
television unit on it face down.
Assembly screw
(Black screw) ....4
) in the explanatory text indicate part numbers in the table of accessories.
Pole
Cloth or similar
Pole ...................2
2. Securing the poles
Front
Pole
Use the assembly screws
bottom of the base.
2. Securing the plasma television
unit
Front
* Carry out work
on a horizontal
and level
surface.
Pole
Nameplate
Use the assembly screws
Lift the plasma television unit above the pedestal base, with the back
of the plasma television unit on the same side as the Nameplate.
Then align the holes in the plasma television unit with the poles of the
pedestal and lower the plasma television unit into place.
Base ..................1
Pole
Base
to secure the poles firmly to the
Plasma
television
Rear
Pedestal
(Black screw) to fasten securely.
unit
3
Publicité
