Axis Q3517-LVE Guide D'installation page 15

1
Connector guard
2
Tab
3
Cable gasket
2. Attach the provided connector guard to the network cable.
3. Pull the tab from the cable gasket farthest from the network connector in the camera
unit.
4. Push the network cable through the cable gasket .
5. Remove the connector guard from the network cable.
6. Route the network cable through the cable gasket.
7. Pull the network cable back slightly so that the cable gasket adjusts itself on the cable.
1
Network connector
2
Tamper-proof screw
AXIS Q3517–LVE Network Camera
15
EN