Télécharger Imprimer la page

Yamaha NS-50F Mode D'emploi page 4

Masquer les pouces Voir aussi pour NS-50F:

Publicité

Les langues disponibles

Les langues disponibles

Connecting Your
Speakers
Always turn off your amplifier or receiver
before making any connections.
■ Preparing Your Speaker Cables
Carefully remove 10 mm (3/8 ") of insulation
from both ends of your speaker cables and twist
the bare wires tightly, as shown.
10 mm
(3/8 ")
Good
■ Hookup
Tighten
Loosen
Amplifier or
receiver
+
4
E-
No Good
+
SPEAKERS
R
L
A
+
B
Notes:
• Make sure that the bare wires are not touching each
other as this could damage the speaker and
amplifier.
• Connect one speaker to the left terminals of your
amplifier, and another speaker to the right
terminals, making sure not to reverse the polarity
(+, –). If one speaker is connected with reversed
polarity, the sound will be unnatural and lack bass.
■ Using a Banana Plug
3
1
1. Remove the speaker terminal cover by
gently pulling it toward you.
2. Tighten the terminal knob.
3. Simply insert the banana plug into the
terminal.
Banana Plug
2

Publicité

loading