Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installing or changing batteries in the remote controller:
1 .
Open the battery compartment on the remote controller using a Phillips
screwdriver (not included) to remove the screw on the battery compartment cover .
2 .
Insert the batteries according to the diagram . Ensure that the positive and
negative polarities match the illustrations inside the battery compartment .
3 .
Replace the battery compartment cover and replace the screw using the
screwdriver . Do not over-tighten .
Important battery information
•
Use only fresh batteries of the required size and recommended type .
•
Do not mix old and new batteries, different types of batteries [standard (Carbon- zinc), Alkaline or rechargeable] or
rechargeable batteries of different capacities .
•
Remove rechargeable batteries from the toy before recharging them .
•
Rechargeable batteries are only to be charged under adult supervision .
•
Respect the correct polarity, (+) and (-) .
•
Do not try to recharge non-rechargeable batteries .
•
Do not dispose batteries in a fire .
•
Replace all batteries of the same type/brand at the same time .
•
The supply terminals are not to be short-circuited .
•
Remove exhausted batteries from the toy .
•
Batteries should be replaced by adults .
•
Remove batteries if the toy is not going to be played with for some time .
Battery
compartment
cover
1.5V LR03
UM4 "AAA"
1.5V LR03
UM4 "AAA"
1.5V LR03
UM4 "AAA"
Battery details
7
Publicité
Table des Matières
