Risk Of Injection Or Severe Cutting Injury; Risk Of Burns; Risk Of Bursting; Risk From Moving Parts - a&i products HPW-1500E Manuel De L'opérateur

READ ALL SAFETY WARNINGS BEFORE USING PRESSURE WASHER
HAZARD
RISK OF INJECTION OR
SEVERE CUTTING INJURY

RISK OF BURNS

RISK OF BURSTING

RISK FROM MOVING PARTS

6
SAFETY WARNINGS
POTENTIAL CONSEQUENCE
Serious injury or death could occur
from high pressure spray penetrating
the skin.
Serious injury may occur from
touching the heat exchanger. This
area can remain hot for some
time after the pressure washer is
shutdown.
Serious injury may occur from a
pressure washer malfunction or
exploding accessories if incorrect
system components, attachments
or accessories are used.
Serious injury or death may occur
if attempting to start the pressure
washer when the pumping system
is frozen.
Serious injury may occur to the
operator from moving parts on the
pressure washer.
PREVENTION
Keep clear of nozzle and spray! Never put your
hand, fingers or body directly over the spray
nozzle.
Do not direct discharge stream at persons or
self.
This product is to be used only by trained
operators.
Always keep operating area clear of all
persons.
Close supervision is necessary when used near
children. DO NOT allow children to operate this
unit!
SEEK EMERGENCY MEDICAL CARE if the spray
appears to have penetrated the skin! DO NOT
TREAT AS A SIMPLE CUT!!
High pressure hoses and fuel lines should be
inspected daily for signs of wear. If evidence of
failure exists, promptly replace all suspect hoses
and fuel lines to prevent the possibility of injury
from the high pressure spray. If a hose or fitting is
leaking, NEVER PLACE YOUR HAND DIRECTLY
ON THE LEAK.
NEVER operate the gun with the trigger wired in the
open position. To prevent accidental discharge,
the trigger gun should be securely locked when
not in use.
Before removing the spray nozzle or servicing
the unit, ALWAYS shut off the unit and trigger the
gun to release trapped pressure. (Even after you
shut off the unit, there is high pressure water left
in the pump, hose and gun until you release it by
triggering the gun.)
Never allow any part of your body to contact the
heat exchanger.
Do not leave unit unattended after shutdown until
it is completely cooled down as described in the
"SHUTDOWN" procedures listed on page 18 of
this manual.
Never make adjustments to the factory set
pressures.
Never exceed manufacturers maximum allowable
pressure rating of attachments.
Do not allow any hoses to make contact with heat
exchanger to prevent the possibility of bursting.
Avoid dragging the hoses over abrasive surfaces
such as cement.
Use only manufacturer recommended repair parts
for your pressure washer.
In freezing temperatures, the unit must always be
warm enough to ensure there is no ice formation
in the pump. Do not start the pressure washer if it
has been transported in an open or underheated
vehicle without first allowing the pump to thaw.
Never make adjustments to the unit while it is
connected to the power source.
Do not operate the unit without all protective
covers in place.
Follow the maintenance instructions specified in
the manual.
Operator's Manual