Advanced Setup (Wi-Fi/Fe Connect Mobile App); Connecting To Wi-Fi - Franklin Electric SubDrive15 Manuel Du Propriétaire

SubDrive/MonoDrive Connect
s
WARNING
!
Serious or fatal electrical shock may result from contact with internal electrical components.
DO NOT, under any circumstances, attempt to modify DIP switch settings until power has been
removed and 5 minutes have passed for internal voltages to discharge! Power must be removed
for DIP switch setting to take effect.
Advanced Setup (Wi-Fi / FE Connect Mobile App)
Some advanced features are able to be modified when connected to the SubDrive/
MonoDrive through Wi-Fi and using the FE Connect mobile app. Follow the instructions
below to connect to the drive and access these advanced settings and features.

Connecting to Wi-Fi

1. The drive's Wi-Fi radio is only able to be connected to within fifteen (15) minutes
following a power-up. If the drive has been powered on for longer than fifteen (15)
minutes, cycle power to the SubDrive/MonoDrive unit.
2. After a few seconds of initialization following power-up, the FE Connect light
will illuminate solid to indicate that a connection is available. If the FE Connect
light is flashing, a previously-connected device is within range of the drive and is
attempting to connect. The FE Connect light is located just below the clear window
of the display.
3. Open the Wi-Fi connection settings on the device you wish to use to connect to the
drive. This is similar to the method used to connect to a normal Wi-Fi hotspot. In
the list of available Wi-Fi connections locate the hotspot named "FECNCT_XXXXX",
where "XXXXX" is the ending portion of the serial number of the drive being
connected to.
4. Connect to the Wi-Fi hotspot. The FE Connect light on the drive will flash to indicate
that a connection is being made. Only one (1) device can be connected to a drive
at any given time.
NOTE: The Wi-Fi connection will stay active for an unlimited amount of time as long
as the mobile device is not disconnected from the drive Wi-Fi. If the connection is
broken, the drive Wi-Fi will be available for reconnection for one (1) hour following a
disconnection. If you wish to reconnect to the drive Wi-Fi after an hour has elapsed,
the drive must be power cycled.
32
FE Connect Light