Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

5.3 Operating

Before first use, clean all removable parts (stirring staff, lid, ice cream container) with
warm water and a mild detergent. Dry all parts afterwards.
Clean the engine and the housing of the device with a soft, damp cloth.
Fill the removable ice cream container with the favored ice cream ingredients.
ATTENTION!
Ice cream container must not be filled more than halfway!
During the final minutes of ice cream preparation the increasing volume of the ice
cream fills up the container.
NOTE!
You should always fill the ice cream container with cooled ingredients and never
with hot ingredients!
Place the ice cream container into the cooling cylinder.
Place the stirring staff into the ice cream container.
Mount the lid safely on to the housing, so that it snaps into the provided fixations.
Now install the engine so that it is connected with the stirring staff and the connector
of the housing.
Close the filling port of the lid with provided cover.
Connect the device to an appropriate single power socket. The red control lamp
flashes up.
Engage the device using the ON/OFF switch
The display shows the preset time of 50 minutes.
The frigistor is engaged automatically after 2-3 minutes and starts cooling the
ingredients in the ice cream container. The green control lamp flashes up.
The stirring staff is automatically set into motion after 7 minutes. You may also
manually engage it before by using the mix switch
By selecting the timer clock
setting to 30, 15 or 5 minutes.
The preparation time for ice cream is approx. 50-60 minutes.
During ice cream preparation, according to your taste, you may add e. g. fruits,
chocolate chips, raisins, nuts, almonds etc. through the filling port of the lid.
When the set time is reached a signal tone resounds and the device switches off the
engine automatically. The frigistor continues operation for another 70 minutes until
the cooling finally shuts off. After approx. 2 – 3 minutes the cooling will be
reengaged automatically.
- 26 -
All manuals and user guides at all-guides.com
on the control panel you may change the time
on the control panel.
.

Publicité

Table des Matières
loading

Table des Matières