W H At To D O; To Cl E A N Yo U R P R; B Ackg R O U N D N O I S E A N D U N D E S I R A B L E I N T Er F Er En Ce S; B Lu E To Ot H I S S U E S - NATIVE UNION PR/01 Mode D'emploi

W H A T T O D O ?
i . T O C L E A N Y O U R P R / 0 1
Before cleaning the device, unplug your PR / 01 from the power socket. Clean the device
only with a dry cloth. Do not use cleaning alcohol or solvent to clean the device's surface
because both of them could damage the painting and cause electrical failures and a fire
if they penetrate the device's electronics.
i i . N O P O W E R
Make sure that the AC cable is solidly connected. Make sure that the plug is fully inserted
in the power socket and there is power. Make sure that the device is switched on by
checking the white LED on the top panel. Make sure that the PR / 01 is not in standby
mode. Press the SOURCE/WAKE button to wake up the device.
i i i . N O S O U N D
Make sure that the volume is turned up to an audible level and that the input source
is at its maximum. Make sure that an available input source is selected. Make sure that
the PR / 01 is not in standby or off mode.Check if the bluetooth connection with your
device is still active.
i v . T H E S O U N D I S D I S T O R T E D O R B U Z Z E S
Check the connections of your audio source. Make sure that all the connecting cables
are correctly plugged in, especially the earth/protection shield connections. Make sure
that your cables are in good condition.
v . B A C K G R O U N D N O I S E A N D U N D E S I R A B L E I N T E R F E R E N C E S
Check the connections of your audio devices. Make sure that all the connecting cables
are correctly plugged in, especially the earth/protection shield connections. Make sure
that your cables are in good condition.
v i . B L U E T O O T H I S S U E S
When connecting a new device make sure the PR / 01 input source is switched to
Bluetooth. If the PR / 01 does not show up on your device make sure to manually refresh
the Bluetooth device list on your phone/device after briefly pressing the PR / 01 Bluetooth
button. There will be a short audio signal once your device makes connection. If you
can't hear any sound make sure the PR / 01 is not in standby and turn up the volume.
Your device may lose connection to the PR / 01 when leaving the Bluetooth range or if
in standby mode. In this case Bluetooth connection can easily be made again from your
phone's Bluetooth settings page (without the need to press the Bluetooth button on the
PR / 01).
Note that depending on your installation and your mobile device the Bluetooth range
will be limited to 5 -10 meters or less if walls or furniture obstruct the signal.
1 9