Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
NOTES:
You only need to pair your computer, tablet or smartphone with the PR / 01 once, after
which the device will be included in the list of your Bluetooth
new device, press the pair button again, and repeat steps above. Your PR / 01 is able to
store up to six devices in its memory.
The Bluetooth® word mark and logos are registered trademarks owned by the Bluetooth
SIG, Inc. and any use of such marks by Design Pool Limited is under license. Other
trademarks and trade names are those of their respective owners.
i i .
C A B L E C O N N E C T I O N
OPTICAL: OPTICAL AUDIO DIGITAL INPUT
Use the optical input to connect your PR / 01 to your TV, hard disk player, streaming
player and satellite or cable receiver. The optical input only works with PCM stereo, if a
connected device sends 5.1 audio (or similar surround sound), the PR / 01 will not work.
To use this connection, you just have to:
1.
Connect the optical audio cable to the optical audio input on your source.
2.
Turn the PR / 01 on.
3.
Select Optical as source by pushing the Control knob.
AUXILIARY 1: RCA ANALOG INPUT
Use the RCA input for connecting your PR / 01 to audio sources such as your mobile
phone, music player or tablet.
1.
Connect the audio cable to your PR / 01 and to the audio output of your music
device (source).
2.
Select AUX 1 as source by pushing the Control knob until the AUX 1 LED is lit.
AUXILIARY 2: 3.5 MM STEREO PLUG
Use the 3.5mm jack input to connect your PR / 01 to audio sources such as your CD
player or turntable (pre-amplified).
1.
Connect the audio cable to your PR / 01 and to the audio output of your music
device (source).
2.
Select AUX 2 as source by pushing the Control knob until the AUX 2 LED is lit.
®
devices. When pairing a
i i i .
U S B C H A R G E R
The PR / 01 comes with a built-in 3-port USB charger. The ports will power your USB
devices even if the speaker is in standby mode. Powering off the PR / 01 with the rear
main switch will also power off the USB ports.
The charger works with most USB compliant devices at 5V and can provide up to 2.4A
charging current (for fast iPad charging) and up to 3A for fast USB-C charging.
NOTE: Never use the charger with damaged cables as those could overheat and cause a
fire. USB-C charging current is limited to 15W. This is enough to charge most phones and
tablets. USB-C laptops should be connected to their original charger which will provide
more power for full functionality. The charger is not compatible with the old iPod Classic
(pre 2010) and other rare devices not fully compatible with the USB standard.
i v .
W I R E L E S S C H A R G E R
The PR / 01 also has a built-in recess inside the top wooden enclosure which can
accommodate the NATIVE UNION wireless charger "DROP" (sold separately). The
DROP can be placed conveniently inside the foam fixation for easy alignment. Wireless
charging connectivity has been tested to work with iPhone X and iPhone 8/8 Plus. When
using other phone models or thick phone cases the wireless charging may not work. In
this case it is recommended to place the wireless charger on top of the speaker instead
of under the wooden enclosure.
*
iPhone is a trademark of Apple Inc, registered in the U.S. and other countries.
1 7
Publicité
Table des Matières
