Temper KLDF-01 Mode D'emploi page 4

3.Test the operation of the Receiver by placing it in close proximity to the transmitter.The
receiver should beep and the LED should flash.
4.Place the scanning head in contact with the face of the circuit breakers or fuses at
a right angle to the direction of the breaker body and run the scanning head steadily
along the row(s) of circuit breakers in just two passes. On the first pass the identifier
calibrates, on the second pass it identifies the circuit.
5.Move the receiver along the row of breakers until the selected circuit is identifiedby
the beep and flashing light.
5 2 Receptacle Wiring Test
-
CORRECT WIRING
GFCI TESTING IN PROGRESS
HOT ON NEUTRAL WTH HOT OPEN
HOT AND GROUND REVERSED
HOT AND NEUTRAL REVERSED
OPEN HOT
OPEN NEUTREAL
OPEN GROUND
OFF ON
1.Plug the Transmitter / Receptacle tester into the outlet.
2.The three LED's will indicate circuit condition. The diagram lists all of the
conditions that it can detect. The LED's in this diagram represent the view from the
GFCI button side of the transmitter. When viewing the other side of the transmitter
the LED's will be a mirror image of those shown here
3.The tester will not indicate the quality of the ground connection, 2 hot wires in a
circuit, a combination of defects, or reversal of ground and neutral conductors.
5 3 Receptacle GFCI Test -
1.Before using the tester, press the TEST button on the installed GFCI receptacle,
the GFCI should trip. If it does not trip, do not use the circuit and call a qualified
electrician. If it does trip, press the RESET button on the receptacle.
2.Plug the Transmitter / Receptacle tester into the outlet. Verify that the wiring is
correct as described above.
3.Press and hold the test button on the tester for at least 8 seconds, the indicator
lights on the tester will shut off when the GFCI trips.
4.If the circuit does not trip, either the GFCI is operable but the wiring is incorrect,
or the wiring is correct and the GFCI is inoperable
5 4 Replacing the Battery -
1.When the battery power is low the LED2 should turn red. The battery should be
replaced
2.Remove slide off cover to replace batteries.(The Transmitter is line powered.)
3.Install 9 volt battery observing the correct polarity.
4.Re-install battery cover
5.Dispose of the old battery properly.
Note:To maximise battery life an auto-power off function is incorporated in the
.
receiver which will turn the receiver off about 3 minutes of inactivity. To resume
testing after this period just turn the unit on as described above.
Rev.110331