Publicité
Les langues disponibles
Les langues disponibles
Circuit Breaker Finder
Circuit Breaker Finder
and GFCI Receptacle Tester
and GFCI Receptacle Tester
KLDF-01
User Manual
1 Introduction
.
Congratulations on your purchase of the meter Circuit Breaker Finder and Receptacle
Tester. This instrument is shipped fully tested and calibrated and, with proper use, will
provide years of reliable service.
2
Meter Description
.
Receiver
1.Scanning head
2.Signal LED1 indicator
3.Low battery LED2 indicator
4.ON/OFF button
5.Battery cover
1
Transmitter
6.GFCI test button
7.Receptacle LED coding scheme
8.Receptacle LED's
3 Safety
.
This symbol adjacent to another symbol, terminal or operating device indicates
that the operator must refer to an explanation in the Operating Instructions to
avoid personal injury or damage to the meter.
This
WARNING
symbol indicates a potentially hazardous situation, which if
WARNING
not avoided, could result in death or serious injury.
This
CAUTION
symbol indicates a potentially hazardous situation, which if
CAUTION
not avoided, may result damage to the product.
This symbol indicates that a device is protected throughout by double insulation or
reinforced insulation.
-
4
3
5
6
7
8
2
4 Specifications
.
Operating Voltage
200 to 240V
Operating Frequency
50Hz
Power supply
9V battery (receiver)
Operating Temperature
5ºC to 40ºC 41ºF to 104ºF
Storage Temperature
-20ºC to 60ºC -4ºF to 140ºF
Max 80% up to
Operating Humidity
linearly to 50% at
<80%
Storage Humidity
7000ft. (2000meters) maximum.
Operating Altitude
218g
Weight
Dimensions
:
Receiver
196 36 55 mm
:
Transmitter
5 Operation
.
WARNING
: Always test on a known good circuit before use.
WARNING
: Refer all indicated problems to a qualified electrician
5
-
1 Locating a Circuit Breaker or Fuse
The transmitter injects a signal onto the circuit which can be detected by the receiver.
The receiver will beep when the signal is detected. The scanning head for tracing and
pinpointing the exact circuit breaker or fuse protecting the selected circuit.
1.Plug the Transmitter / Receptacle Tester into a powered outlet. The two green LED's
should illuminate.
2.Press and release to ON/OFF button. The red LED1 should turn on and the LED2
should turn green. If the LED2 should turn red, replace the battery
(
)
(
C)
31ºC 87ºF
(
) decreasing
40ºC 104ºF
(
)
x
x
118 60 35 mm
x
x
Publicité
