Wezag WDT UP 14 Z Mode D'emploi page 39

Installation of safety guard:
Die set with locator (Fig. 7.2)
1. Install the safety guard 3 with the larger
opening and tighten the screws.
2. Install the locator holding fixture 2 and
tighten the screw.
3. Put the locator on the locator holding
fixture 2.
CAUTION
The larger opening of the safety guard is only allowed to be used with mounted locator
+
holding fixture and mounted locator.
Die set without locator (Fig. 7.3)
1. Install safety guard 3 with smaller
opening over the operating area and
tighten the screws.
BDA UP 14 Z – 03/15 – REV. 0
3
2
Fig. 7.2
3
Fig. 7.3
Page 39 / 71