Kohler K-1835-JH-96 Instructions D'installation page 6

Install the Whirlpool (cont.)
NOTE: The pump support (when the pump banding straps are cut) must rest directly on the subfloor.
The pump control should not be in contact with mortar.
With help, carefully lift the whirlpool into position.
Fit maximum 1/8" (3 mm) spacers under the bath rim so the rim does not contact the deck.
Apply weight to the bath basin until the mortar sets.
Secure the Nailing-In Flanges (Alcove Units)
Drill a small pilot hole through the nailing-in flange at each stud. Add shims as needed.
Use large-head galvanized nails to secure the nailing-in flange to the studs.
Nail 1/4" (6 mm) thick furring strips to the studs.
Cut the Pump Banding Straps
IMPORTANT! Perform this step to make the whirlpool operate more quietly.
Cut the two pump banding straps from the whirlpool pump.
NOTE: Do not raise the pump higher than it was before you cut the straps. If the pump is raised too
high, it will not prime properly. Make sure that the rubber isolation feet are in place.
Install the Plumbing
Insert the drain tailpiece into the trapway. Secure the drain tailpiece to the trapway.
Install the faucet valve.
Check the drain connections for leakage.
If required, install the grab bars according to the instructions.
1193346-2-G
6 Kohler Co.