Kohler K-1835-JH-96 Instructions D'installation page 4

Alcove
(Bath with Apron)
1. Prepare the Site
NOTICE: Measure your actual product for site preparation. Note the model number located on the
whirlpool pump, then visit the product page at kohler.com for additional information.
NOTICE: Provide generous, unrestricted access to the pump. Provide access for servicing the pump. The
access must be located immediately next to the pump.
NOTICE: Do not lift the whirlpool by the piping or pump, or use the piping or pump for structural
support of the whirlpool. To avoid damage to the whirlpool, lift at the sides of the whirlpool.
NOTICE: Do not support the load weight of the whirlpool by the rim. Plan to shim under the bath as
needed when leveling the bath.
NOTICE: Bath may require shimming when installing an apron.
NOTE: Drop-in, alcove, or corner installation is possible, depending on the product chosen.
Carefully unpack and inspect the new whirlpool for damage before installation. If there is damage,
do not install the whirlpool; contact your dealer.
Make sure that the flooring offers adequate support for your whirlpool, and verify that the subfloor
is flat and level.
Construct 2x4 stud framing according to the product dimensions found on the product page at
kohler.com.
Install an access panel for future pump servicing. The access panel must be at least 30" (762 mm)
wide by 15" (381 mm) high.
Install the rough plumbing.
Install the drain to the whirlpool according to the drain manufacturer's instructions.
Protect the whirlpool surface by positioning a clean drop cloth in the basin bottom.
1193346-2-G
Alcove
(Bath without Apron)
4
Drop-In
Access
Panel
Kohler Co.