Electrical Connection - Resol PSW Basic Manuel

2.2 Electrical connection

WARNING! Electric shock!
Upon opening the housing, live parts are
exposed!
Î Always
vice from power supply before
opening the housing!
ATTENTION! ESD damage!
Electrostatic discharge can lead to da-
mage to electronic components!
Î Take care to discharge proper-
ly before touching the inside of
the device!
Note
Strong electromagnetic fields can impair the functi-
on of the device.
Î Make sure the device as well as the system are
not exposed to strong electromagnetic fields.
disconnect the de-
Note
It must be possible to disconnect the device from
the mains at any time.
Î Install the mains plug so that it is accessible at
any time.
Î If this is not possible, install a switch that can
be accessed.
If the mains cable is damaged, it must be replaced
by a special connection cable which is available from
the manufacturer or its customer service.
Do not use the device if it is visibly damaged!
Connecting the device to the power supply must always be
the last step of the installation!
The device is supplied with power via a mains cable. The
supply voltage must be 230 V~ (50 Hz).
Connect the signal cable from the controller to the low
voltage input of the device:
R In N max. 240 V = neutral conductor N from the
controller
R In L max. 240 V = 230 V control signal from the con-
troller (conductor L)
17