Fein KFH17-8 Mode D'emploi page 17

Mounting indexable inserts (figure 6).
After you have inserted the milling head, you
can mount the three indexable inserts.
Press the locking button fully through and
hold it in place.
Position the indexable insert and fasten it
with the screw using the Torx 15 screw-
driver.
Rotate or turn around the eightfold heads as
required. Please note that milling head, guide
rollers and indexable inserts may vary
depending on the application. Only use acces-
sories approved for the application.
Fig. 6
TX 15
3.5 - 4.0 Nm
3.
Indexable
inserts
1.
Locking button
1.
4.
5.
8.
en
Torx 15 screwdriver
4.
2.
8x
2.
3.
180°
6.
7.
17