Fein KFH17-8 Mode D'emploi page 15

Dismounting indexable inserts
(figure 3).
After you have removed the guide roller, you
can remove the three indexable inserts.
Press the locking button fully through and
hold it in place.
Loosen the screw with the Torx 15 screw-
driver. Then remove the indexable insert.
Dismounting the milling head
(figure 4).
After you have removed the guide roller and
the indexable inserts, you can remove the
milling head.
Press the locking button fully through and
hold it in place.
Loosen the milling head with the (5 mm)
Allen key. Then, remove the milling head.
Fig. 3
Torx 15 screwdriver
TX 15
2.
3.
4.
Fig. 4
2.
3.
en
Indexable
inserts
1.
Locking button
Allen key
5 mm
Milling head
1.
Locking button
15