Operation; Led Indicators; Lcd Display/Functions; Use - Elipson Infinite A1000 Mode D'emploi

EN
IV. OPERATION

1. LED indicators

Standby mode : red
On mode : blue

2. LCD display/Functions

When you turn on your amplifier, the display shows the volume and the selected mode (SUB/LFE).
The navigation inside the DSP is managed using the navigation buttons on the remote control or the button
in front of the amplifier.
From the first screen, you can adjust the volume using the button on the amplifier or the Down/Vol- and
Up/Vol+ buttons on the remote control. In order to enter the setting menu of the DSP, you have to press the
amplifier button or the Menu/Enter button on the remote control. To select the desired parameter, press the
amplifier button or the Menu/Enter button on the remote control.
Note : A long press on the amplifier button allows it to go in standby mode. A short press on the same button
allows the amplifier to reactivate.

3. Use

Home screen (volume)
This is the screen displayed when you turn on your
amplifier. It allows you to adjust the output volume.
Press the Menu/Enter button to access the DSP
settings.
Subsonic frequency
The "Subsonic Freq" setting allows you to limit the
low frequency range of the sub and is generally
used to protect subwoofers from over-excursion
and/or damage from operating below the
subwoofer's tuning frequency. A "flat" setting is
provided to remove the filter, or a filter frequency
can be set from 20.3Hz to 40Hz.
22