GreenWorks Commercial GT 160 Mode D'emploi page 11

ASSEMBLY
ATTACHINg THE guARD (See Figure 2.)
NOTE: Install the guard before the attachment is connected to the lower shaft.
1. Invert the string trimmer to access the trimmer head.
2. Remove supplied screws (1) from the guard with a philips screwdriver.
3. Place the guard (2) on to the trimmer head.
4. Align the screw holes on the guard (3) with the screw holes on the trimmer head (4).
2
5. Insert the screws into the trimmer head, fastening the guard in place using a philips head
screwdriver (not included).
1
3
4
11
Fig. 2.1
Fig. 2.2
Fig. 2.3