Eurotops WS8120 Guide D'utilisation page 7

INSTALLATION
1. Remove the protective film at the front of the clock.
2. Place your clock face down on a flat and soft surface.
3. Slide off and remove the battery cover at the back of your unit.
4. Insert 2 x new AA batteries (not included) into the battery compartment by observing the correct
"+" and "-" polarity.
5. Slide on and replace the battery cover.
Reminder:
 Alkaline batteries are recommended for optimal usage of this clock.
 Do not mix old and new batteries.
 Do not mix alkaline, standard or rechargeable batteries.
DCF SIGNAL RECEPTION AND SIGNAL INDICATOR
After your clock is powered up, it starts to receive DCF signal. The
Receiving DCF signal
Successful Reception
Failed Reception
AUTOMATIC RECEPTION AND MANUAL RECEPTION
Your clock starts automatic reception everyday at 1:00, 2:00, and 3:00. If it fails to receive the DCF77
time signal at 3:00, it will start reception at 4:00. If it fails again, it will start reception at 5:00. If it fails
again, it will start automatic reception at 1:00 again in the next day.
MANUAL RECEPTION
Press and hold +, your clock will start manual reception. Press and hold + again to stop the current
DCF reception.
During RCC reception, all buttons do not function and it does not take temperature measurement.
TO TURN ON/OFF RADIO CONTROLLED TIME
When you use this clock in a country where the DCF signal is not available, you can turn off the
function of DCF radio controlled time.
Press and hold both + and – few seconds until the upper right LCD shows "DCF OFF". Your
clock will return to normal time display and it will not search for DCF signal automatically everyday.
To turn on the function again, press and hold both + and – until "DCF ON" appears.
TO SET DST, TIME ZONE, TIME, 12/24HR, CALENDAR
Press and hold SET, "DST ON" flashes, press + or – to select "DST OFF" if need.
1.
Press SET again, "GMT+1" flash, press + or – to select :-
2.
GMT+0 Western European time (U.K., Ireland, Portugal)
GMT+1 Central European time (e.g. Germany, Switzerland, Spain, France, Italy)
GMT+2 Eastern European Time (e.g. Finland, Ukraine, Romania)
GMT+3 Turkey
Press SET again, "HOUR" appears and hour digit flash, press + or – to set hours.
3.
Press SET again, "MINUTE" appears and the minute digits flash, press + or – to set minutes.
4.
Press SET again, "24HR" flashes, press + or – to select 24HR 12HR. In 12Hr mode, AM will
5.
appear on the display to indicate morning time. PM will appear on the display to indicate
afternoon time.
( icon flashing)
( icon becomes static)
( icon disappear)
EN2
icon flashes.