Firex PM.G A Serie Manuel D'installation, D'entretien Et D'emploi page 37

Table 6 – Gas inlet pressure
Table 6a
Nominal main pressure for the different
types of gas
Table 6b
Operation permissible if pressure is in the
range:
Table 6c
Operation non permissible if pressure is
lower than:
Table 6d
Operation non permissible if pressure is
higher than:
Main structure in steel with 4 adjustable height feet.
−
Panels in stainless steel AISI 304, thickness 10-12/10.
−
Cooking vat in stainless steel AISI 316, thickness 20/10.
−
Lid in stainless steel, hinged and spring balanced in all opening positions.
−
Chrome-plated brass drainage tap.
−
Vat heating controlled by means of high efficiency stainless steel tubular burners resistant to
−
mechanical and thermal stress.
The gas supplied to the burner is adjusted by a cock.
−
The appliance has a pilot burner with fixed injector, besides piezoelectric ignition.
−
The safety of the appliance is ensured by a thermocouple that cuts off the gas flow if the pilot burner
−
should turn off for any reason.
The cold/hot water connection is 10 mm. (Mod. 100/150lt.)
−
The cold/hot water connection is ½". (Mod. 200/300/500/170/270/370lt.)
−
The appliance is equipped with a mixer tap.
−
Stainless steel lid with heat-resistant silicone gasket.
−
Hermetically sealed with 4 screw clamps.
−
The relief valve for the pressure that develops in the cooking chamber is set at 0.05 bar.
−
Instruction manual for installation, maintenance and use
Gas Kettles PM.G...A
Gas family 2 – Natural
Gas family 3 –LPG
Gas family 2 – Natural
Gas family 3 –LPG
Gas family 2 – Natural
Gas family 3 –LPG
Gas family 2 – Natural
Gas family 3 –LPG
1.3. CONSTRUCTION
1.3.1. SPECIAL FEATURES FOR PRESSURE KETTLES
(MODELS PM...... A)
20 mbar
28-30/37 mbar
da 17 a 25 mbar
da 20/25 a 35/45 mbar
17 mbar
20/25 mbar
25 mbar
35/45mbar
- GB - 9 di 28
Page