Datamars 46000W Mode D'emploi page 9

Compliance
FCC warning
Note:
Users are cautioned that changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This equipment should be installed and operated with a minimum distance of 20 cm (8") between the antenna within
this device and your body.
Responsible party in the USA
This product is supplied by:
Datamars Inc
528 Grant Road
Mineral Wells
Texas 76067
UNITED STATES
Toll free: 800 874 8494
ISED Canada warning
Installation within Canada: To maintain compliance with ISED Canada RF exposure compliance requirements, please
follow the operation instructions as documented in this manual. This equipment should be installed and operated with
a minimum distance of 20 cm (8") between the antenna within this device and your body.
ISED Canada notice
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic
Development Canada's licence-exempt RSS(s). Operation is subject to the following two conditions:
(1) this device may not cause interference
(2) this device must accept any interference, including interference that may cause undesired operation of the device.
EU declaration of conformity
Datamars Limited hereby declares that the radio equipment type 46000W is in compliance with the
essential requirements and other relevant provisions of Radio Equipment Directive 2014/53/EU. The
declaration of conformity may be consulted at: https://datamars.com/compliance
Bluetooth
The ® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such
marks by Datamars SA and its subsidiaries is under license. Other trademarks and trade names are those of their
respective holders.
All trademarks with an * are neither owned by nor licensed to Datamars SA and belong to their respective owners.
9