Rinsing The Milk Circuit; Cleaning And Maintenance; General Cleaning; Drip Tray And Used Capsule Drawer - Tchibo Saeco Cafissimo HD8603 Mode D'emploi

• 26 •
13- Lift the lever to eject the used capsule into the used capsule
drawer.
14- Remove the cup, mug or glass from the grille.

Rinsing the milk circuit

To always ensure optimal hygiene, the milk circuit must be quickly
rinsed after use.
The user is reminded to do this by the rinse button
It remains on until the circuit has been rinsed or the machine has
been turned off.
To rinse the milk circuit, proceed as follows:
1- Ensure that the milk carafe is in the machine.
2- Place a container under the milk dispensing spout.
3- Press the rinse button
The machine dispenses a quantity of water sufficient to rinse the
milk circuit. Once finished, remove the container.
Finally, always remember to put the carafe with the remaining milk
in the refrigerator.
The rinse milk circuit function helps the machine to
maintain optimal hygiene conditions and service,
but in no case should it be considered sufficient as the only
way of cleaning the carafe and milk circuit.
Always clean the carafe as described in the chapter ''Cleaning
and Maintenance'' .
When preparing milk/cappuccino, steam may issue
from the steam outlets. This is not a malfunction.

CLEANING AND MAINTENANCE

General cleaning

1- Cleaning can only be done when the machine has cooled and
been unplugged from the mains supply.
2- Do not immerse the machine in liquids.
3- The only removable components that are dishwasher safe are:
the drip tray, the grille and the internal parts of the frothing
system (see section "Weekly cleaning of the milk carafe").
4- Do not use sharp objects or harsh chemical products (solvents)
for cleaning.
5- Use a soft, dampened cloth to clean the machine.
6- Do not dry the machine and/or its components using a micro-
wave and/or standard oven.
lighting up.
.

Drip tray and used capsule drawer

The used capsule drawer must be emptied after approximately every
8-10 coffees brewed.
Check periodically that the used capsule drawer is
not full so as to avoid malfunctions and damage to
the machine.
1- Pull out the drip tray as shown in the
figure.
2- Remove the used capsule drawer by
pulling out the drip tray as far as it
goes.
3- Push the sliding lock on the left side of
the used capsule drawer upwards and
pull out the drip tray.
4- Empty out the liquid in the drip tray.
5- Empty the used capsule drawer.
6- Wash and dry before reinserting it.
7- Wash out the inner compartment of
the machine.