Important; Installation Instructions; Tools And Parts; Unpack The Water Cooler - Whirlpool B10P Guide D'utilisation Et D'entretien

Tools and Parts

Gather the required tools and parts before starting installation.
Tool needed
Flat-blade screwdriver or 7 mm hex nut driver
Parts Supplied
Check that all parts are included.
Drip tray
Part Needed
3 or 5 gal. (11.4 or 18.9 L) water bottle ready to use

Unpack the Water Cooler

WARNING
Excessive Weight Hazard
Use two or more people to move and install
water cooler and bottles.
Failure to do so can result in back or other injury.

IMPORTANT:

Allow the water cooler to stand upright for a minimum of
1 hour after unpacking it and before plugging it into an
electrical outlet. This allows the refrigerant to settle properly
and avoids damage to the cooling system.
Remove the plastic bag and discard.
Remove tape from drip tray and discard.
Dispose of/or recycle all packaging materials.
4

INSTALLATION INSTRUCTIONS

Shelf (model D25)

Location Requirements

NOTE: This water cooler is recommended for indoor use only.
Check location where water cooler will be installed. The location
must provide:
A 2" (5 cm) clearance between the water cooler and the wall.
IMPORTANT: For best performance, do not place the water
cooler near an open flame, radiator or other heat source.
Grounded 3 prong outlet.
Install where water cooler is sheltered from the elements.
Protect against freezing to avoid possible rupture of drain
line. Such ruptures are not covered by the warranty. See
"Storing the Water Cooler" for winter storage information.
If the water cooler will be left unused for a period of time or in a
location where it may be subject to freezing, follow the
instructions in "Storing the Water Cooler."

Electrical Requirements

WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
A 120 volt, 60 Hz, AC only, 15- or 20-amp fused, grounded
electrical supply is required.