Publicité
Les langues disponibles
Les langues disponibles
"
1/2
X 1-1/4" BOLT
"
1/2
FLAT WASHER
"
1/2
LOCK WASHER
"
1/2
NUT
FLANGE
CHEVY EXPRESS and GMC SAVANA
1. Center the hitch under the frame as far rearward as possible against the end of the frame. Clamp in place.
2. Loosely attach the bolt on brackets as shown. It will bolt in next to the spring hanger. You may need to move the hitch
slightly rearward to give it room next to the spring hanger support.
3. Using the hole in the flange as a guide, drill 1/2
and insert through the frame and install 1/2
existing holes in the frame.
"
4. Torque 1/2
nuts to 70 ft•lb.
92-
03 FORD ECONOLINE and SUPER WAGON, 04-06 ECONOLINE EXCEPT E-350
'
'
1. Attach the hitch to the van using the existing holes at the end of the frame. Insert 1/2
down through the holes in the frame and the hitch. Install 1/2
2. Attach the bolt on brackets (shown) to the hitch as shown in the diagram with 1/2
"
and 1/2
nuts. Leave the nuts loose.
"
3. Insert 1/2
x
long hex bolts with bolt plates down through the holes in the frame and the hitch. Install 1/2
1
"
3/4
"
1/2
lock washers, and 1/2
"
4. Torque 1/2
nuts to 70 ft•lb.
BOLT PLATE
1/2
1/2
96-
06
'
'
"
holes through the bottom of the frame. Install 1/2
"
flat washer, 1/2
"
"
nuts. Drill 1/2
holes in the frame for these bolts if your frame holes don't line up.
"
1/2
X 1-3/4" HEX BOLTS
"
LOCK WASHER
"
NUT
"
lock washer, and 1/2
"
flat washers, 1/2
TOOLS REQUIRED
1/2"
3/4"
3/4"
TORQUE WRENCH
SAFETY GLASSES
"
bolt through bolt plate
"
nut. You will not be able to use the
"
x
long hex bolts with bolt plates
1
"
3/4
"
"
lock washers, and 1/2
nuts.
"
x
long hex bolts, 1/2
1
"
1/4
DRILL BIT
SOCKET
WRENCH
BOLT ON BRACKET
"
lock washers,
"
flat washers,
Publicité
