Wall Inlet Installation - NuTone CV-350C Instructions D'installation

WALL INLET INSTALLATION

MODEL 360C SERIES WALL INLETS
(361 Rough-in)
1. Once the walls have been finished, install the wall inlets.
2. Remove the cardboard plaster guard.
3. Refer to Figure 13. For some dry wall or panel construction,
the plaster frame will extend beyond the finished wall.
In this case, remove plaster frame from mounting bracket
by removing mounting screws.
4. Refer to Figure 14. Connect 2-conductor low voltage wire
to terminal screws on back of wall inlet.
5. Guide excess wire back through hole in inlet bracket
and make sure seal is secure between mounting bracket
and flanged fitting.
6. Refer to Figure 15. Place inlet into mounting bracket
and secure.
NOTE: Refer to Figure 16. When wall inlets are
1
installed in ⁄ " thick walls or less, the tube of the wall
2
inlet may extend into elbow area of the flanged fitting
and cause blockage. Shorten the wall inlet tube to
prevent this condition.
For extra thick walls, use extension sleeves to connect inlet
to the flanged fitting.
MODEL 330C SERIES WALL INLETS
(329 Rough-in)
Refer to Figure 17.
1. Connect 2-conductor low voltage wire to terminal screws
on back of wall inlet.
2. Align inlet mounting holes with holes in mounting plate.
3. Place inlet into mounting plate and secure with two
provided screws.
6
FIGURE 13
FIGURE 15
WALL
FIGURE 16
INLET
FIGURE 17
FIGURE 14
MODEL 365
DOUBLE FLANGED
TEE
WALL
INLET
SHORTEN
MOUNTING
BRACKET
MOUNTING
PLATE