Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INSTALLING WALL INLET
1. Make cutout according to dimensions in Figure 30.
2. Refer to Figure 31. Break off nail plate at scored line.
3. Refer to Figure 32. Glue elbow to mounting plate, place
assembly into cutout, and attach elbow to tubing inside
the wall.
4. Make sure mounting holes are exactly at top and bottom.
1
/
"
4
3
2
/
"
4
3
/
" DIA.
8
7
3
/
"
8
3
/
" DIA.
8
1
3
/
"
8
1
/
"
FIGURE 30
4
FLOOR INLET INSTALLATION
INSTALLATION IN NEW AND EXISTING CONSTRUCTION
1. Refer to Figures 34 and 35. After floor inlet location has
1
been selected, cut a 3
⁄
16
line of inlet must be located at least 2
cover to be opened when hose is inserted.
2. Determine direction of tubing and attach appropriate flanged
fitting to mounting bracket with four (4) screws supplied.
Be sure mounting bracket flange does not interfere
with tubing and seal is securely in place.
3. Refer to Figure 36. Position bracket with frame and flanged
fitting assembly into cutout from below and secure to sub
floor.
TOP VIEW
1
3
/
"
16
FIGURE 34
10
FIGURE 31
9
" x 2
⁄
" square hole in floor. Center
16
1
⁄
" from wall to allow
2
9
2
/
"
16
MOLDING
WALL
5. Connect 2-conductor low voltage wire to terminal screws
on back of wall inlet.
6. Refer to Figure 33. Align inlet mounting holes with mounting
plate holes, place inlet into mounting plate, and secure with
provided screws. NOTE: If 382-SC shorter radius elbow is
used, it may be necessary to use the short mounting screw
to avoid interference with elbow.
MOUNTING
PLATE
ELBOW
MOUNTING
HOLE (2)
FIGURE 32
4. Refer to Figure 37. Large end of extension sleeve should
be cut to length to allow proper seating of inlet against floor
or carpet.
5. Refer to Figure 38. Pull Low Voltage 2-Conductor wire
through mounting bracket and attach to terminal screws on
back of floor inlet. Cement extension sleeve to inlet. Insert
extension sleeve through vinyl gasket in mounting bracket
and firmly seat into flanged fitting.
6. For convenience of operation, floor inlet should be installed
to open back toward wall.
7. Refer to Figure 36. Secure floor inlet in place with
two screws.
SIDE VIEW
FIGURE 35
INLET
MOUNTING
PLATE
FIGURE 33
1
2
/
" MIN.
2
APPROX.
MOUNTING BRACKET
FLANGE
Publicité
Chapitres
Table des Matières
