Kalorik PRO B60A Manuel De L'utilisateur page 12

Maintenance and Protection
1. When the machine is running, never put hands or any other object into the
barrel.
2. When the machine has worked for a long time, you must let it cool down and
restart the machine.
3. It is not adaptable to run the machine for a long time continuously, make sure
the machine can be used better and longer.
4. Pulling the gear and belt by hands is prohibited in order not to injure.
5. Clean the bowl and agitator after use in order to keep them healthy.
6. The up and down orbit are added a little lube.
7. Put a glass of lube on the hand wheel axle at a regular time.
8. All axletrees and gears have put into excellent lube. Usually, these spare parts
can be used for half a year, and if you need to take them apart and put the
lube, you can take apart the box cover and adding lube hole of cover of shift
box.
9. Take apart the ventilation cover, and put some certain lube to cone gear.
10. Check the belt loose or tight.
1. Clean and spray the mixer by water pipe is prohibited.
2. If you maintain the mixer, you must cut off the power source and ask the professional
electricians to fix it.
3. Touching the electrical switch and power source with wet hands is prohibited.
4. When there are some damages in the machine, stop using it.
5. There is an equal potential connecting the ground in the mixer. When the
machine needs to be repaired and be smooth to repair finally, take off the ground wire.
6. Teenagers cannot be close to the mixer.
7. The mixer must fix on the dry wooden splint and there is safety-working zone in it.
In order to keep safety, when using mixing device I / II / III, please
pay attention to insert their grooves which are from the handles into
the spiral axle pin separately. Furthermore, rising bowl to the highest
position, so that the edge of the bowl is higher than mixing device I /
II / III working position.
- 12 -