Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
5. Preparing the devices for use
1. Charge the powerpack
WARNUNG
Pay attention to the safety notes on page 4-6.
Charging process
•
Plug the mains cable into the socket on the charger, then connect the
mains cable with the outlet socket of the electric power supply.
NOTE
Compare the local electric power supply with the connection values of the
device. Should the connection values not match, please contact
info@walimexpro.de or phone +49 8432-9489-0.
•
Insert the powerpack into the charging bay of the battery charger. Ensure
correct polarity.
•
The device starts charging.
•
The LEDs for the powerpack charge condition light up, in dependence on
the charge condition.
•
Once the device has been charged, all LED's of the powerpack charge
condition light up.
NOTE
The time required for a complete charging of the powerpack can take up to
approx-. 4 hours.
40
1. Inserting the power pack
Inserting the
Opening the a cover
power pack
Slide the battery cover
Insert the powerpack
in direction of arrow
as shown. Ensure
and lift it up.
correct polarity + / - of
the powerpack.
ACHTUNG
■ Be careful when changing the battery. After operation the
batteries may be hot.
■ If you do not use the device remove the batteries, to prevent the device
from being damaged by running out battery fluid.
Closing the battery
cover
Slide the battery cover
back to initial position
in direction of arrow.
41
Publicité
Table des Matières
