marklin 60883 Mode D'emploi page 17

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 20
Testing a Set up Contact
In order to test a contact, which has been set up, you can
select your set up contact in the CS3 under „View" (Item
List). If you now short circuit the set up contact at your L88
by using a wire at the ground connection, the contact will
light up yellow in the item list on the CS3.
Swapping Devices.
If you need to swap out a device, the new L88 can be reset
to the previous device number. Resetting is done after re-
gistering the L88 in the CS. Give the new S88 the number of
the device it is replacing at „ID". After that, the CS has to be
restarted, and now all of the contacts will function as usual.
17

Publicité

Table des Matières
loading

Table des Matières