Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Unfasten screws and remove 2 support brackets (J) from the hood unit (Fig.
Secure the support brackets (J) to the motor unit (G) using the 4 screws (V4 Ø3.9×9.5), taking the desired air outlet direction
into consideration (Fig.
).
2
E
1
J
The motor used in the motor unit (G) is, by default, equipped with a check valve already installed.
If required, remove them from the air outlet fitting of the motor.
F
Check valve
Place the motor unit (G) on the ceiling (Fig.
template (B) (Fig.
).
2
G
J
G
1
), taking care to center the assembly by means of the flaps (A) of the protection
G
1
1
).
2 -1
G
J
V4
4 - Ø3.9×9.5
2
A
2 -2
G
J
V4
4 - Ø3.9×9.5
B
19
Publicité
Chapitres
Table des Matières
