Panasonic FV-36RBQL1HD Mode D'emploi Et Notice D'installation page 18

INSTALLATION (MOTOR UNIT PLACED ON THE RANGE HOOD)
Refer to Chap. "MAINTENANCE", remove the perimeter suction panel and the metal filters
completely.
Hood unit : Remove the flange (C) (Fig.
Motor unit : Remove the bracket (D) and the motor flange (E) (Fig.
[ In case of duct direction change ]
Unfasten 8 screws and washer, and then remove the flange (F) from the motor unit (G) (Fig.
Define the air outlet direction by rotating the flange (F) (Fig.
Securing the flange (F) to the component (H) with 8 screws and washer (Fig.
The motor unit (G) can also be installed on the Range Hood in various positions in order to have the desired air outlet
direction (Fig. ).
6
D
1
[ Factory setting ]
Motor unit
G
4
H
F
18
).
1
5A
C
[ In case of duct direction change ]
3
washer
5A
washer
F
H
).
2
).
).
5B
2
V2
Ø4.2×12.5
(
Note :
Keep screws and
washers to install the
motor unit (G) on
the Range Hood
4 - washer
V3
8 - Ø3.9×9.5
F
8 - screw
Ø3.9×9.5
H
5B
, ) .
3 4
D
(x2)
)
E
6
G
G