Italtecnica Nettuno 3P-13A Manuel D'instruction page 30

PIPE-MOUNTING
Nettuno can be mounted onto a horizontal pipe by means of a kit of fixing collars (optional, to be ordered
separately). 4 different collar sizes are available, as shown in the diagram below.
PIPE MOUNTING KIT
CODE
KIT-TUBO114
KIT-TUBO112
KIT-TUBO200
KIT-TUBO212
For simple installation of the product, proceed as described below.
1) Fix the bracket to the pipe by means of the
"U-shaped" hooks and 4 bolts supplied. See fig.
6 for selection of the holes.
3) Pre-assemble the fixing screws on the rear
side of Nettuno, leaving a space of at least 3
mm under the screws
DESCRIPTION
Kit for fixture on pipes of 1" ¼
Kit for fixture on pipes of 1" 1/2
Kit for fixture on pipes of 2"
Kit for fixture on pipes of 2" 1/2
.
2) Ensure that the bracket is securely fitted on
the pipe and cannot rotate.
4) Insert Nettuno onto the bracket, passing the
screw heads on the larger holes and then slide
downwards.
30