Tre Spade MNS0022 Mode D'emploi page 10

ducts. In order to maintain your meat mincer
in perfect conditions for very long time, it's
a good rule, after any operation of cleaning
and washing, to dry it accurately (mainly its
processing unit).
If a long not-working period of the mincer is
foreseen, a cast iron surface light lubrication
will help to maintain the working group in
perfect conditions.
MAIN CHARACTERISTICS OF THE TOOLS
WHICH CAN BE INSTALLED IN THE
MACHINE
The machine is supplied with a plate (P) each
hole of which has a diameter of 6/8 mm in
order to comply with rule UNI EN 294 para-
graph 4.5 (access through openings).
To perform different processing operations,
however, it is possible to fit in plates (P) with
holes having a smaller diameter compared
with the plate supplied by the manufacturing
Company without modifying the functional
characteristics of the machine. If a supply is
needed, please refer to TAB. A.
F.A.C.E.M. SpA - TRE SPADE - shall not be held
responsible for any accidents deriving from
the use, on the "ELECTRIC MEAT MINCER", of
plates with holes having a diameter of more
than 8 mm. which are easily available on the
market because they can be used on meat
mincer operated by hand. In fact, if these
plates are used without taking specific pro-
tecting measures in order to bring the safety
standards within the range required by law,
the safety parameters requested by the abo-
ve mentioned rules are no longer complied
with (see Fig. 6).
MAINTENANCE
Parts which are subject to wear mainly inclu-
de the cutting elements, in this case the bla-
de and the perforated plate.
The condition of these components should
be checked regularly, and sharpening of the
TRE SPADE TRE SPADE
same, if necessary, should be done by com-
petent personnel. These parts must be repla-
ced when it is necessary.
Every now and then check the conditions of
bush (D) placed between the screw and the
body. In case of abnormal wear it should
also be replaced to avoid possible damage to
other parts of the machine.
It is advisable to use original spare parts
made by the manufacturing Company to
avoid any inconvenience due to different ma-
nufacturing characteristics.
In the order of spare parts the model, the se-
ries number indicated on the label of motor
group MT (and on the conformity declara-
tion) and the reference letter of the part (see
Fig. 1) must be specified.
For models with gears operating in oil bath
(see the attached list) follow carefully these
notes: the oil supplied is MOBILGEAR 636 (Vi-
scosity cSt 40° C 636; Viscosity cSt 100° C 37,1
ISO 680). A change every 300 working hours
with the same oil or with similar (of the same
viscosity) oils for reduction units is recom-
mended.
Models with MT 1 (see Fig. 2):
- For the topping-up, put the power unit (MT)
in vertical position, unscrew the oil plug
(10) placed in the front part of the reduc-
tion unit, pour the a.m. oil up to cover the
oil window positioned in the same oil plug.
Then retighten the plug and place again the
power unit (MT) in horizontal position.
- For the oil changing, unscrew as the oil
plug, and allow the output of the oil to be
changed from the motoreducing group
(MT): a good dripping must be attained.
Pour the new oil in quantity of about 125
cm3 and retighten the plug.
For the MT4 model, proceed as for the MT1
model (see Fig. 2) after removing the gear
motor from the stainless steel casing that
contains it.
Made in Italy Made in Italy