Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
TROUBLE SHOOTING
PROBLEM
Motor Stops to
Start
Fails to split logs
The log pusher
moves jerkily,
taking unfamiliar
noise or vibrating
a lot
Oil leaks around
cylinder ram or
from other points.
PROBABLE CAUSE
Overload Protection Device
disengaged to protect the log
splitter from being damaged
Log is improperly positioned
The sizes or hardness of the log
exceeds the capacity of the
machine
Wedge cutting edge is blunt
Oil leaks
Unauthorized adjustment was
made on Max. Pressure
Limiting Screw. Lower max
pressure rating was set.
Lack of hydraulic oil and
excessive air in the hydraulic
system.
Air sealed in hydraulic system
while operating.
Bleed Screw is not tightened
before moving the log splitter.
Oil Drain Bolt with Dipstick is not
tight.
Hydraulic Control Valve Assembly
and / or seal(s) worn
REMEDY SUGGESTED
Contact a qualified Electrician for opening
the Pushbutton Box to engage the
Overload Protection Device inside *
Refer to " Log Splitter Operation" section
for perfect log loading.
Reduce the log sizes before splitting it on
the log splitter
Refer to " Sharpening Wedge " section to
sharpen the cutting edge.
Locate leak(s) and contact the dealer
Contact the dealer.
Check oil level for possible oil refilling.
Contact the dealer.
Loosen Bleed Screw by 3 ~ 4 rotations
before operating the log splitter
Tighten the Bleed Screw up before
moving the log splitter.
Tighten the Oil Drain Bolt with Dipstick.
Contact the dealer
39
Publicité
Table des Matières
