gala gar D-16 C Manuel Technique D'instructions page 13

2.1. ASSEMBLING MACHINES.
The electrical installation of the equipment making up the system must be carried out by specialised
personnel according to the standards in force.
The location must meet the following requirements:
Place: Dry and ventilated, far enough away from the welding area in order to prevent the metal dust
caused by the welding process from getting into the equipment. The equipment must not be used in the rain.
The electrical connection of the wire-feed unit is carried out with an extension, which connects it to the GALA
INDUSTRIAL/MODULATE power source.
The general installation process is described in the GALA INDUSTRIAL/MODULATE power source manual.
Read this section carefully.
Power source Bottle support
GALA MIG 3007
Ref: 430.00.000
GALA MIG 4100
Ref: 420.00.000
GALA MIG 4100
COMPLET
Ref: 422.00.000
MODULATE 4000
Ref: 430.84.000
SUPPORT
Ref: 420.12.080
GALA MIG 4007
Ref: 431.00.000
MODULATE 5000
Ref: 431.83.000
GALA MIG 4100
COMPLET
Ref: 422.00.000
GALA MIG 5100
Ref: 421.00.000
Ref: 432.12.080
INCLUDED IN
GALA MIG 6007
Ref: 434.00.000
D-16 C, D-22 C. Instructions Manual.
RECOMMENDED MACHINE ASSEMBLY
Cooling unit
BOTTLE
TROLLEY WCS-510
Ref: 634.00.000
INCLUDED IN
POWER POWER
SOURCE SOURCE
Set of cables Wire feeder
Ref: 637.00.000
2
(5 m; S=35 mm )
Ref: 637.81.000
2
(10 m; S=35 mm )
Ref: 628.00.000
Ref: 637.82.000
2
(20 m; S=50 mm )
Ref: 639.00.000
2
(5 m; S=70 mm )
Ref: 639.81.000
2
(10 m; S=70 mm )
Ref: 638.82.000
2
(20 m; S=70 mm )
Ref: 629.00.000
Ref: 639.87.000
2
(5 m; S=95 mm )
Ref: 629.00.000
Ref: 639.89.000
2
(10 m; S=95 mm )
Torch
MX-36
D-16C
Ref: 23600004
MIG 511
Ref: 885114M
MX 501
D-22C Ref: 25100004
MIG 511
Ref: 885114M
D-22C
MX 501
Ref: 25100004
13