Graco SnugRide Classic Connect 32 Guide

To Remove Existing Harness Tongues and Buckle and Attach Replacement Buckle
You will receive ONE of
these Graco approved
replacement buckles.
Follow instructions for
proper installation.
4
Remove chest clip.
DO NOT DISCARD
the chest clip.
7
Slide NEW buckle
onto harness straps.
MAKE sure not to
twist straps.
10
Re-insert straps back onto splitter plate.
See carseat owner's manual to choose
correct set of harness loops for your child.
SnugRide® Classic Connect™ 32/35,
Buckle Replacement Guide
Also for Infant SafeSeat, SafeSeat Step1, Teutonia Tario, Teutonia Tario 32
and Teutonia Tario 35
1
To loosen straps, lift lever
and pull harness straps.
5
Unbuckle harness
red button, and
8
Re-attach chest clip.
MAKE sure not to
twist straps.
Remove harness
2
strap loops from
splitter plate.
6
by tilting top of
buckle down,
press top of
pull tongues
out of buckle.
9
Re-insert straps through slots
in seat pad and seat back.
See carseat owner's manual
for proper height setting for
your child.
Turn page over to
fi nish the rest of
the assembly
Steps 11 to 16
for the buckle
replacement.
©2014 Graco PD265292E 7/14
3
Pull harness straps
through seat back and
seat pad.
Remove and
discard tongues.