Drinkwell CURRENT-S-BR-EU-19 Guide De Démarrage Rapide page 5

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 9
7.
Once the intake plate is removed, remove the impeller
(white, 3-bladed propeller). The impeller is held in
place by a magnet. Simply use a fingernail to get
underneath the blade and lift out (Fig. 7).
8. Rinse all pet fountain parts, including the pump, with
warm water before operating the pet fountain. This will
remove any dust or residue that remain in the system
from the manufacturing process. Then reassemble the
pump and pet fountain, leaving only the lid off.
9.
Rinse the charcoal filter thoroughly under cold water
before placing in the pet fountain. This will remove any loose
carbon dust, which is harmless. A small amount of carbon
dust may also shed for the life of the filter. This is normal and
not harmful to your pet.
10. Insert the charcoal filter. The filter will fit between the two
triangular slots on the opposite side of the pump from the
pump plate. Make sure it is pushed all the way down and
that the black side of the charcoal filter is facing toward the
pump (Fig. 8).
Replace charcoal filter every two to four weeks.
11. Attach the lid by pressing down until you hear it snap
in place.
12. Place the pet fountain in a desired location. Fill the pet
fountain by pouring water directly into the bowl, this will
prime the pump. Leave at least 6 mm of space between the
water level and the rim of the bowl.
13. Before you plug in the pet fountain, make sure the electrical power cord, the power
adapter and your hands are dry. Connect the in-line plug and make sure no silver is
showing, then plug the power adapter into a mains power outlet (Fig. 9).
14. Never let the water level fall below 5 cm from the base of the bowl or you might risk
pump failure. Add water to the bowl as needed.
15. Clean the pet fountain once a week. Hand wash the pet fountain plastic
parts with warm water and soap. This pet fountain may also be cleaned with a diluted
vinegar solution (20% vinegar, 80% water). Important: Be sure to rinse thoroughly
with fresh water. You can also put the pet fountain in the top rack of the dishwasher.
Remove the pump before placing the pet fountain in the dishwasher. Only rinse the
filter with water.
www.petsafe.net
Fig. 7
Fig. 8
Fig. 9
5

Publicité

Table des Matières
loading

Table des Matières