Use - Cleanmaxx PC-P003WH Mode D'emploi

EN
Removing / Inserting the Collecting Container

Use

CAUTION!
■ Never hold the nozzles close to parts of your body or animals during use and do
not place your hands inside the nozzles. They could become stuck to the device /
injured. Should the cordless vacuum cleaner become stuck, switch the device off
immediately.
■ Switch on the device only once you have ensured that the suction nozzle, the col-
lecting container, the fi lter compartment and the fi lter have been inserted correctly.
■ Always switch the device off fi rst before you attach or remove a nozzle!
■ On no account should the device be used to suck up the following:
– Glowing ash, cigarette ends, matches, etc.
– Infl ammable or explosive substances
– Very fi ne dust (e.g. concrete dust), ash or toner
– Pointed, hard objects such as large pieces of broken glass
■ Empty and clean the collecting container after each use (see the "Cleaning and Stor-
age" chapter).
■ Do not use the device when it is connected to the adapter.
Switch the device off after each surface has been cleaned as this will considera-
bly increase the operating time on each battery charge.
1. Place one of the nozzles into the suction opening. However, you can also use the
cordless vacuum cleaner without a nozzle.
2. Press the On/Off switch to switch on the device.
3. Guide the nozzle over the surface to be cleaned. During use, check whether the col-
lecting container is already full. If this is the case, it needs to be emptied.
• Removing: Hold the device with the collecting container point-
ing downwards. Press the button for releasing the collecting
container and remove the main unit from the collecting con-
tainer.
• Inserting: On the bottom edge of the main unit there is a lock-
ing lug. Plug this into the associated slot in the collecting con-
tainer. Then press the two parts of the device together at the top
until the locking mechanism is heard to lock in place. It may be
necessary to press the release button here. Then check wheth-
er the collecting container is fi tted in place properly.
■ IMPORTANT: If there is liquid in the collecting container, do
not overfi ll it and do not turn the device over with the top
pointing downwards so that no water can get into the ventila-
tion opening in the fi lter compartment and thus to the motor!
20