Makita ML702 Mode D'emploi page 6

ML902
Voltage Battery cartridge
9.6 V
Storing battery cartridge
Always charge the Nickel Metal Hydride battery cartridge
before storing it when you do not use it for more than six
months.
Head angle (Fig. 5)
The head angle can be adjusted in four stages. Adjust as
desired.
Replacing bulb (Fig. 6 & 7)
CAUTION:
The bulb is very hot immediately after operation. Wait until
the bulb cools off before attempting to replace it.
First, turn the ring counterclockwise and remove the
reflector. Remove the bulb holder by turning it coun-
terclockwise. Then replace the bulb.
Shoulder strap (Fig. 8)
Install the strap on the tool.
6
9000
9002
9033
Operating time
Approx. 160 min.
Approx. 230 min.
Approx. 260 min.
MAINTENANCE
To maintain product safety and reliability, repairs, main-
tenance or adjustment should be carried out by a Makita
Authorized Service Center.
ACCESSORIES
CAUTION:
These accessories or attachments are recommended
for use with your Makita tool specified in this manual.
The use of any other accessories or attachments
might present a risk of injury to persons. The acces-
sories or attachments should be used only in the
proper and intended manner.
• Bulb set (2 pcs)
• Shoulder strap
• Set plate (For Model ML903)
Charger
DC9710, DC9711, DC1201,
DC1411, DC1439, DC1470,
DC1422, DC1801
DC9711, DC1201, DC1411,
DC1439, DC1422, DC1801
DC9711, DC1411, DC1439,
DC1422, DC1801