EINHELL Deluxe I Mode D'emploi page 10

GB
covered with protective foil on both sides.
The side with the printed foil is the outside of the web
panel (with UV coating). Only remove the protective
film from the plastic web panel you are currently
installing.
PAGE 86
26/h + 26/i: Fit a PVC panel (Item 10) and an air inlet
(Item 7) to the bottom half of the door. To do so, first
fit the panel into the notch on the air inlet, then slide
both parts into the guide rails of the side door profiles
from below until the panel engages into the door
center profile. The ventilation grille of the air inlet
must face outwards.
PAGE 87
Left-hand door wing
PAGE 88
26/k: First push the long hexagon head bolt M6x20
into the top guide rail of the door center profile
approximately 13 cm from the left edge.
Secure with a washer and a hexagonal nut without
flange. Then slide another bolt with a nut into each of
the two guide rails approximately 5 cm from the right
and left edges.
PAGE 90
26/n: Fit three pre-assembled hinge blades (step) to
one side of a door profile. Mount one hinge blade in
the center of the profile, the other two hinge blades
approximately 10 cm from the right and left edges.
26/o: Fasten the pre-assembled lock catch to the
second door profile (side).
26/q + 26/r: You can fit a PVC panel or a transparent
plastic web panel to the top half of the door.
PAGE 94
27: Assembly of the double door
27/a: Place the two door wings on the door hinges
and align the hinges that belong together on the door
wings and the door wings themselves so that they
can engage precisely in each other.
PAGE 96
28: Fitting the right door latch
28/a: Assembly preview: Pre-assembly of the right
door latch
10
PAGE 97
28/b: Fit the two door latches to the pre-assembled
rivets on the handle strip. Ensure that the angled
ends of the door latch point upwards (see Figure
28/a).
28/c: Pre-assembly of the side latch
PAGE 98
28/d: Secure the bush for the door latch to the
outside of the door. If necessary pre-drill the bolt
holes.
PAGE 99
Important note:
The individual bolt pre-assembled in step 26/b in the
top guide rail of the door center profile with hole must
be positioned between the handle strip and the door
profile as shown in Figure 28/g. This bolt serves as
the end stop for the turning strip and must therefore
be tightened directly next to it.
28/g: Fit the door latch so that the ends point away
from the door.
PAGE 100
Important: Fit the guide plates as shown in Figures
28/i and 28/j.
PAGE 101
Note: The side latch will slide in front of the door
profile of the other door wing as soon as the handle
is turned. The door is now locked.
28/k: Fasten the side latch to the door profile with the
appropriate guide plate. If necessary pre-drill the bolt
holes.
Important: Make sure that the guide plate is fitted in
such a way that the latch can be moved in horizontal
direction.
PAGE 102
Note:
If the door does not close correctly or the rods catch
slightly when the door is opened, undo the bolts on
the door hinges and align the height of the door
wings precisely.
PAGE 103
Fitting the left door latch
28/m: Assembly preview, pre-assembly
Closing mechanism (left door wing)