Nespresso BARISTA W10 Guide De L'utilisateur page 6

Important safeguards
Avoid risk of fatal electrical
shock and fire
Only plug the power base into a
•
suitable, grounded power socket. Make
sure that the voltage of the power
source is the same as that specified on
the rating plate.
Unplug from outlet when not in use
•
and before cleaning. Allow to cool
before putting on or taking off parts,
and before cleaning the appliance.
Plug cord into the wall outlet. To
•
disconnect, switch off, then remove
plug from wall outlet.
Do not pull the cable over sharp edges,
•
clamp it or allow it to hang down.
If the supply cord or the plug are
•
damaged, they must be replaced by
the manufacturer, its service agent or
similarly qualified persons.
Disconnect the power base from the
•
power socket, when not in use for long
periods. Disconnect by pulling out the
plug and not pulling the cable itself, as
this may damage the cable.
Never immerse the power base of
•
appliance in water or other liquids.
Electricity and water together can
cause a fatal electric shock.
To protect against fire, electric shock
•
and injury to persons do not immerse
cord, plugs, or the device base in
water or other liquid.
Disconnect the device from the mains
•
before the appliance is cleaned, and
ensure that the inlet is dried before the
appliance is used again.
6
The appliance is only to be used with
•
the jug provided.
Short power-supply cords reduce risks
•
resulting from becoming entangled in
or tripping over a long cord.
Longer (or detachable) cords may be
•
used if care is exercised in their use,
and:1) the marked electrical rating is at
least as great as the electrical rating of
the appliance 2) a grounding-type 3-
wire cord is used 3) cord(s) is arranged
so that it will not drape over the
counter top or table top, where it can
be pulled on or tripped over by anyone.
If an extension lead is required,
•
use only an grounded cable with a
conductor cross-section of at least
1.5 mm / 0.06 in
2
The Barista jug is dishwasher safe, but
•
cannot be washed at a temperature
higher than 70° C / 158 F.
Magnets inside.
•
Hot elements after heating: jug,
•
use handle.
Hot surface under jug: risk of
•
damaging of table (wood, plastic) or
surface when put.
Don't use without lid, risk of hot
•
beverage projection and don't
remove lid during appliance working.
Don't put your fingers or foreign
•
body during preparation: rotating
parts, risk of injury.
Don't fill jug with more liquid than max
•
level, risk of overflowing.
Don't close opening (cooling air
•
.
2