Storage Of The Device - FUXTEC FX-MT152 Mode D'emploi

Original Bedienungsanleitung FUXTEC FX-MT152/-MT152E/-MT252_de_en_fr_ita_rev19
3. Visually check the spark plug for damage and electrode burn-off,
Remove the carbon deposits
4. Check the gap with a feeler gauge and bend the electrode to the
distance of 0.6 to 0.7mm
5. Check the spark plug washer and tighten the spark plug with a
12-15 Nm
6. Fit the ignition cap back onto the spark plug
WARNING
The spark plug must be screwed down tightly; otherwise, the engine runs hot and is
damaged.
Sharpen the shield knife
1. Remove cutting blade (E) from a protective shield
(F).
2. Clamp the knife in a vice. Sharpen the knife with a
flat-file. Please make sure that you maintain the angle
of the cutting edge. Only move the sharpening knife in
one direction during the sharpening process.
Warning!
If adjustments to the carburetor have to be made, this
must be carried out by a specialist workshop.

Storage of the device

WARNING: Failure to follow these steps may result in the formation of
deposits in the carburetor. This will make starting difficult and cause
permanent damage
1. Perform all general maintenance as described in the maintenance section of your
user manual are recommended.
2. Clean the exterior of the device, drive axle, protective shield, and nylon cutting head.
3. Drain fuel from the fuel tank.
4. After draining fuel, start the engine.
5. Let the device run in neutral until the device stops on its own. This will clean the
carburetor of fuel.
6. Let the device cool down (about 5 minutes).
7. Use a spark plug wrench, remove the spark plug.
8. Pour 1 teaspoon of clean 2-stroke oil into the combustion chamber. Pull the starter
cord
slowly several times to coat internal components. Replace the spark plug.
96
0.6~0.7m 0.6~0.7m
correct
m m
torque of