Trimming Techniques - FUXTEC FX-MT152 Mode D'emploi

Original Bedienungsanleitung FUXTEC FX-MT152/-MT152E/-MT252_de_en_fr_ita_rev19

Trimming techniques

CAUTION
IF YOU are NOT familiar with the trimming techniques, practice with the DEVICE in the
"STOP" position (turned off).
ALWAYS TRIM OR CUT AT HIGH ENGINE SPEEDS. Do not run the device slowly at the
start or in trim mode.
ALWAYS MAKE DISTANCE IN THE WORKING AREA from cans, bottles, rocks, etc.
Whirling objects can cause serious injury to users or bystanders and damage the device.
If an object is accidentally knocked, immediately stop the DEVICE and check the device.
Never run the device with damaged or defective parts.
DO NOT use the device for any purpose other than trimming grass.
Never lift the nylon cutting head above knee height during operation.
Do not run the device on a slope if there is a chance of slipping or losing stability.
RELEASING THE NYLON THREAD
To release fresh thread, run the device at full throttle and tap the nylon
cutting head onto the lawn. The thread releases automatically. The blade in
the protective shield cuts off excess thread.
CAUTION: Remove grass deposits regularly to prevent overheating of the
drive axle. Grass deposits occur when fibers of the weed become entangled
around the shaft under the protective shield. This prevents the shaft from
cooling correctly. Remove grass deposits with a screwdriver or similar tool only when the
device is switched off.
When the device is appropriately equipped with a protective shield and nylon cutting
head, your device will trim unsightly weeds and large diameter tall grass in areas along
fences, walls, land, and around trees.
NOTE: Pay particular attention when trimming on brick or stone walls, etc., where rapid
91