Refueling The Engine - FUXTEC FX-MT152 Mode D'emploi

Original Bedienungsanleitung FUXTEC FX-MT152/-MT152E/-MT252_de_en_fr_ita_rev19
chapters.
NOTE: Always pull the starter cord straight out. Pulling the starter at an angle will cause
the rope to rub against the eyelet. Pulling the starter at an angle can cause the starter
cable to fray or break. Always hold the starter handle firmly when the rope is pulled
back. Never allow the rope to be thrown back from the pulled-out position. This could
damage the starter device.
Warm start of the engine
Place the device on a firm and flat surface.
1.
2. Slide the engine stop switch down
3. Slide the choke to the "WARM START" position
4. Pull out the starter rope with a short-stroke until resistance is felt
(about 100mm). A continuous high-speed train will provide a strong spark and start the
engine
If the device does not start, please proceed again according to "Cold start of the engine
Stopping the device
Unlock the throttle. Let the device return to idle. Push the engine stop switch on the
handle upwards until the device stops. If it does not stop, pull out the spark plug
connector in an emergency. Never leave the device unattended while it is running.

Refueling the engine

FUEL AND 2-STROKE OIL
Use unleaded gasoline with 2-stroke engine oil in a 40:1 ratio. During the first few
operations, a mixture ratio of 25:1 can be selected to initially lubricate all device parts
optimally.
WARNING: Never use pure gasoline in your engine. This will cause permanent engine
damage and voids the manufacturer's warranty for this product. Never use a fuel
mixture that has been stored for more than 90 days.
WARNING: This must be a premium grade, 2-stroke air-cooled engine oil.
FUEL MIXTURE
Mix fuel with 2-stroke oil in a container provided for this purpose. Note the following
the mixture table on the following page for the correct fuel/oil ratio. Shake the tank to
ensure complete mixing.
89