Summer 3Dpac cs lite Mode D'emploi page 11

Use this section to
attach car seat
models:
• NEVER install Infant Car Seat without fastening it securely to the stroller with the provided car seat straps.
Car seat must be in rear facing position only. • ALWAYS remove the tray before attaching the infant car seat
to the stroller with the car seat straps. • NEVER lift the stroller by infant carrier handle.
• Use only with Summer™ Affirm™ 335, Graco® SnugRide® Click Connect™ 35, Graco® SnugRide®
SnugLock® 35, Chicco® Keyfit® 30, Chicco® Fit2® and Baby Trend® Secure Snap Gear® 35. Other car
seats or carriers are not designed to fit this stroller frame and may result in serious injury or death. NEVER
use them as they have not been safety tested.
1 Remove tray.
4
attaching a car seat:
WARNING
2 Fold canopy back. 3 Make sure seat is fully reclined.
Place the car seat into
stroller in the rear facing
position so that it is in full
contact with both the stroller
seating surface and seat
back.
NOTE: check car seat for
secure fit in stroller.
11