Publicité
Les langues disponibles
Les langues disponibles
M4300 -EX Front Panel Features
Power LEDs
Indicates the status of the rear panel
Power Button
outlets. LEDs for each outlet bank
Press and hold for 2 sec-
will be lit when the outlets are turned
onds to turn Bank 2 out-
ON. They will flash during the start-
lets ON or OFF.
up and shutdown process.
M4300-EX
BANK 1
ALWAYS ON
POWER AND FILTRATION
M4300 -EX Back Panel Connection Features
Outlet Bank 1
Four always on outlets. Power will only be turned off under a fault
condition. (See specifications for over-voltage and under-voltage
thresholds)
The High Current outlet provides power from a non-inductive
noise filtration circuit that does not limit the current to your equip-
Circuit Breaker
ment. Its output is noise isolated from all of the other outlets.
Automatically opens
when the current load
Power from the other three always on outlets is cleaned by a two-
is greater than 15
stage tapped Pi filter circuit which provides noise isolation from
Amps. Push to reset.
both the High Current outlet and Outlet Bank 2.
MAIN POWER
15 AMP
HIGH CURRENT
120 VAC/15A
CIRCUIT
BREAKER
GROUND
LUG
SUB / RECEIVER
Main Power
Ground Lug
Must be plugged
Provides a common
into a properly
grounding point for
wired & ground-
equipment with sep-
ed 3-wire outlet
arate ground leads.
Unsafe Voltage Indicator
Normally Off. Flashes to indicate that the incoming
line voltage is unsafe and the unit has disconnected
the power to protect your equipment.
BANK 2
WIRING
UNSAFE
ON
OK
VOLTAGE
Wiring OK LED
Normally On. Indicates
that the wall outlet is
properly grounded and
Line/Neutral polarity is
correct.
BANK 1 ALWAYS ON
DVR
HDTV / MONITOR
HD CABLE / SAT
Note to CATV Installers:
This reminder is provided to call attention to Article 820-40 of the NEC. That article provides specific
guidelines for proper grounding.It specifies that the cable ground shall be connected to the grounding
system of the building and as close to the point of entry as practical.
Outlet Bank 2
Four switched outlets controlled by the front panel
Power Button. EMI/RFI noise filtration is provided by a
two stage tapped Pi filter circuit which also provides
noise isolation from all four outlets in Bank 1.
BANK 2 SWITCHED
DVD
DIGITAL RADIO
CD
Home Theater Power Conditioner
Satellite TV Coax Jacks
Bidirectional protection cir-
cuit optimized for satellite TV
signal lines. Do not use for
cable TV off-air antennas
and cable modems.
10/100bT LAN AND PHONE
LINE IN
EQUIP. 1
EQUIP. 2
LAN
TEL
AUX / VCR
LAN / Phone Jacks
Protection circuits for 10/100
baseT Ethernet and standard tele-
phone or pay-per-view lines.
Phone circuit is auto-resetting.
Incoming LAN or phone cords
MUST be plugged into the LINE
jack. Patch cords to the equipment
(satellite receiver, digital video
recorder, telephone, etc.) MUST be
plugged into the EQUIP jacks..
Cable TV Coax Jacks
Bidirectional protection cir-
cuit optimized for cable TV,
off-air antennas and cable
modem signal lines. Do not
use for Satellite TV.
SATELLITE
CATV / ANT
Publicité
