Resolution Setting; Antenna Connection - Pioneer HTZ-BD91HW Mode D'emploi

Resolution Setting

The player provides several output resolutions for
HDMI OUT and COMPONENT VIDEO OUTPUT jacks.
You can change the resolution using [Setup] menu.
1. Press HOME MENU (n).
2. Use A/D to select the [Setup] and press ENTER
(b). The [Setup] menu appears.
3. Use W/S to select [DISPLAY] option then
press D to move to the second level.
4. Use W/S to select the [Resolution] option
then press ENTER (b) to move to the third level.
5. Use W/S to select the desired resolution then
press ENTER (b) to confirm your selection.
, ,
Note
y If your TV does not accept the resolution
you have set on the player, you can set
resolution to 480p as follows:
1. Press B to open the disc tray.
2. Press Z (STOP) for more than 5 seconds.
y Since several factors affect the resolution of
video output, see "Video Output Resolution"
on page 62.

Antenna connection

Connect the supplied antenna for listening to the
radio.
Rear of the unit
, ,
Note
After connecting the FM wire antenna, keep
it as horizontal as possible. Be sure to fully
extend the FM wire antenna.
Connecting 21
2