Introduction; Specifications; Electrical Data; General Data - GMC-I PRO SyS CP 30 Mode D'emploi

2. INTRODUCTION

The CP 30 and CP 35 current probes have been
designed for use with multimeters and oscilloscopes
respectively for accurate, non-intrusive measurement of
AC, DC and complex waveform currents.
Using advanced Hall Effect technology the CP 30 /
CP 35 can measure currents accurately with a
resolution of 1mA from 5mA to 30 Amps over the
frequency range of DC to 100 kHz.
These features make it a powerful tool for use with
inverters, switch mode power supplies, industrial
controllers and other applications requiring current
measurement and/or waveform analysis.
3. SPECIFICATION

3.1 Electrical data

(All accuracies stated at 23° C ± 1° C)
Nominal current In .................... 20 AC
Measuring range ...................... 0 to ±30 A
Overload capacity..................... 500A (60s)
Overall DC accuracy................. ±1% of reading ±2mA
Resolution ................................ ±1mA
Typical output noise level ......... 200µV r.m.s.
Gain variation ........................... ±0.01% of reading/° C
Output sensitivity ...................... 100mV/A
Frequency range ...................... DC to 20kHz (CP 30)
di / dt response......................... 20A/µs
Response time ......................... better than 1µs
Working voltage..................... 300V AC

3.2 General data

Operating temperature ............. 0° C to +50° C
Storage temperature with
battery removed ....................... -20° C to +85 ° C
Power supply............................ 9 V Alkaline battery
Battery life ................................ 30 hours typical
Load impedance (minimum) ..... > 100kΩ and ≤ 100pF
DC to 100kHz
(CP 35) (0.5dB)
PP3, MN 1604
or IEC6LR61
4
or DC
RMS
or DC
RMS